ISO INTERNATIONAL STANDARD 15818 First edition 2017-03 Earth-moving machinery Lifting and tying-down attachment points Performance requirements Engins de terrassement - Points d'ancrage pour le levage et I'arrimage - Exigences de performance Reference number IS0 15818:2017(E) International Organization for Standardization @ IS0 2017 ee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 mitted without license from IHS IS0 15818:2017(E) COPYRIGHT PROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Licensee-ZHEJIANG INST OF STANDARDIZAISQ 017 - All rights reserVed Not for Resale, 2017/5/16 00:40:06 networking permited without license from IHS IS0 15818:2017(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions ..1 4 Lifting attachment points. ..4 4.1 Location and number 4 4.2 Strength .4 5 Tying-down attachment points .6 5.1 Location and number ..6 5.2 Acceleration coefficient .. 6 5.3 Strength. 7 6 Attachment points - Common reguirements .9 6.1 Common locational requirements. 6.2 Material requirements. .10 6.3 Pull-pin type devices. 10 6.4 Common devices. .10 7 Identification ..10 8 Lifting and tying-down instructions ..11 9 Verification ..12 Annex A (normative) Lifting and tying-down information for disassembled machines ..13 Annex B (informative) Lifting, loading, tying down and transporting earth-moving machinery - Methods and recommendations. .14 Annex C (informative) Method for calculation of forces on tying-down attachment points in diagonal lashing disposition. 19 Bibliography .20 ii icensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vithout license from IHS