ISO INTERNATIONAL STANDARD 15841 Second edition 2014-08-15 Dentistry Wires for use in orthodontics Médecine bucco-dentaire - Fils pour utilisation en orthodontie Reference number ISO 15841:2014(E) ISO @IS02014 No reproduction or networking permitted without license from IHS Not for Resale IS0 15841:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved or networking permited without license from IHS Not for Resale IS0 15841:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. 2 Normative references 3 Terms and definitions 4 Classification ..2 5 Requirements .3 5.1 General 3 5.2 Dimensions 3 5.3 Austenite finish temperature. 3 5.4 Mechanical properties .3 5.5 Hazardous elements. .3 6 Test methods. .3 6.1 Sampling. .3 6.2 Dimensions .3 6.3 Austenite-finish temperature 6.4 Mechanical tests. ..5 7 Packaging and labelling information to be provided to the user ..8 7.1 General requirements 7.2 Packaging. ...8 7.3 Labelling. .9 Bibliography .10 tnematonladzarightsrerved iii ded by IHS under lic cense with ISt ed without license from IHS Not for Resale