ISO INTERNATIONAL STANDARD 16063-45 First edition 2017-05 Methods for the calibration of vibration and shock transducers Part 45: In-situ calibration of transducers with built in calibration coil Méthodes pour I'étalonnage des transducteurs de vibrations et de chocs- Partie 45: Partie 45: Etalonnage sur site des transducteurs munis d'une bobine d'étalonnage intégrée Reference number IS0 16063-45:2017(E) International Organization for Standardization @ IS0 2017 ZHEJIANG INST OF STANDARDIZATION C1 5956617 IS0 16063-45:2017(E) COPYRIGHT PROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Licensee-ZHEJIANG INST OF STANDARDIzoISQ 07 - All rights reserved Not for Resale, 2017/8/21 00:59:20 networking permited without license from IHS IS0 16063-45:2017(E) Contents Page Foreword ..iv 1 Scope 1 2 Normative references ..1 3 Terms and definitions 4 Calibration .2 4.1 General 2 4.2 Calibration procedure ..3 4.2.1 General 3 4.2.2 Calibration in laboratory .4 4.2.3 In-situ calibration 4 4.3 Preferred amplitudes and frequencies 5 5 Uncertainty of measurements ..5 6 Report of calibration results Annex A (normative) Expression of uncertainty of measurement in calibration Annex B (informative) Example of uncertainty calculation. ..11 Annex C (informative) Application notices for using this document ..16 Bibliography ..17 iii nSee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 ithout license from IHS