ISO INTERNATIONAL STANDARD 16122-1 First edition 2015-03-15 Agricultural and forestry machinery - Inspection of sprayers in use - Part 1: General Matériel agricole et forestier - Controle des pulvérisateurs en service - Partie 1:Généralités Reference number IS0 16122-1:2015(E) ISO International Organization for Standardization see=Zhejang Institute of Standardization 5956617 @IS02015 No reproduction or networking permitted without license from IHS IS0 16122-1:2015(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Inteationai br DrganizationforStandardization Not for Resale, 2015/6/2 07:16:34 No reproduction or networking permited without license from IHS IS0 16122-1:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. 2 Normative references 3 Terms and definitions 4 Criteria for classification of sprayers ..1 5 Pre-inspection requirements .2 5.1 General. .2 5.2 Place for inspection. .2 5.3 Pre-inspection .2 5.3.1 General .2 5.3.2 Cleaning. 2 5.3.3 Power transmission parts 2 5.3.4 Movingparts 2 5.3.5 Pipes and hoses for hydraulic transmission. .3 5.3.6 Structural parts and framework. .3 5.3.7 Lockable foldable parts 3 5.3.8 Blower. .3 6 Inspection ..4 7 Test report ..4 Annex A (informative) Parts of Is0 16122 dealing with specific sprayer types ..5 Bibliography 7 iii icensee=Zhejiang Institute of Standardization 5956617 without license from IHS Not for Resale, 2015/6/2 07:16:34