ISO INTERNATIONAL STANDARD 16143-3 Secondedition 2014-05-15 Stainless steels for general purposes - Part 3: Wire Aciers inoxydables pour usage général - Partie 3: Fil Reference number ISO 16143-3:2014(E) SO International Organization for Standardization Zhejiang Institute of Standardization 5956617 IS02014 r networking permitted without license from IHS IS0 16143-3:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Prganizationfor Standardization Not for Resale, 2015/3/11 02:25:35 networking permitted without license from IHS IS0 16143-3:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Designation ..2 5 Information to be supplied by the purchaser ..2 6 Manufacturing conditions .3 6.1 General. .3 6.2 Treatment conditions. .3 6.3 Surface finish 3 7 Requirements .4 7.1 Manufacturing process ..4 7.2 Delivery condition 4 7.3 Chemical analysis ..4 7.4 Mechanical properties 4 7.5 Tolerances on dimensions .5 8 Inspection, testing, and conformance of products .5 8.1 General .5 8.2 Inspection and testing procedures and types of inspection documents ..5 8.3 Specific inspection and testing .6 8.4 Test methods .6 8.5 Retests ..6 9 Packing and marking ..6 Annex A (informative) Designations of the steels given in Table 1 and of comparable grades covered in ASTM, EN, JIS, and GB standards. .16 Bibliography .19 iii vided by IHS underI thout license from IHS