ISO INTERNATIONAL STANDARD 16462 Second edition 2014-06-01 Cubic boron nitride inserts, tipped or solid Dimensions, types Plaquettes en nitrure de bore cubique, brasées ou monobloc - Dimensions, types Reference number ISO 16462:2014(E) ISO International Organization for Standardization see=Zhejang Institute of Standardization 5956617 @IS02014 vided by IHS under No reproduction or networking permitted without license from IHS IS0 16462:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Internatinai br DrganizationforStandardization HS und Not for Resale, 2015/3/11 02:27:4 networking permited without license from IHS IS0 16462:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ..1 3 Insert shapes and design 3.1 Insert shapes .1 3.2 Normal clearance an. 3.3 Cutting edge corner. 1 3.4 Tolerance class 3.5 Design of cutting edges .2 3.6 Insert type. .2 4 Designation .2 4.1 General .2 4.2 Designation of inserts for turning. .2 4.3 Designation of a tipped insert for milling .2 5 Dimensions. .3 5.1 Insert shape T with fixing hole (inserts for turning) .3 5.2 Insert shape S with fixing hole (inserts for turning) .4 5.3 Insert shape C with fixing hole (inserts for turning) .5 5.4 Insert shape D with fixing hole (inserts for turning) 5.5 Insert shape V with fixing hole (inserts for turning) .7 5.6 Insert shape S with fixing hole (inserts for milling) ..8 5.7 Insert shape C with fixing hole (inserts for milling) .9 5.8 Insert shapes C, R, S, and T without fixing hole (inserts for turning). .9 5.9 Insert shapes S and T without fixing hole (inserts for milling) .11 5.10 Insert shapes S and T without fixing hole (inserts for milling) ..12 5.11 Insert shape W with fixing hole (inserts for turning) 5.12 Insert shape W without fixing hole (inserts for turning) ..14 6 Cutting edge length, l1, of tipped inserts ..15 6.1 General .15 6.2 Inserts with radius. .15 6.3 Inserts with wiper edge .. 15 1 Base material, cutting material ..16 8 Measurements. ..16 9 Marking ..16 Annex A (informative) Relationship between designations in IS0 16462 and IS0/TS 13399-2....17 ii vided by IHS under lic without license from IHS Not for Resale, 2015/3/11 02:27:44