ISO INTERNATIONAL STANDARD 16525-8 First edition 2014-05-15 Adhesives Test methods for isotropic electrically conductive adhesives - Part 8: Electrochemical-migration test methods Adhésifs - Méthodes d'essai pour adhésifs a conductivite électrique isotrope Partie 8: Méthodes d'essai de migration électrochimique Reference number IS0 16525-8:2014(E) ISO International Organization for Standardization @ IS0 2014 ted without license from IHS IS0 16525-8:2014(E) COPYRIGHTPROTECTEDDOCUMENT ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Prganizationfor Standardization Not for Resale, 2015/3/11 02:28:2 etworking permitted without license from IHS IS0 16525-8:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Principle 5 Apparatus and test circuit board 5.1 Preparation of test coupon. ..4 5.2 Measurement wiring. ..4 6 Test. .5 6.1 Test conditions .5 6.2 Test procedure. 6.3 Judgment. ..8 7 Test report .8 Bibliography .9 iii see=Zhejiang Institute of Standardization 5956617 vided by IHS under ed without license from IHS