ISO INTERNATIONAL STANDARD 16525-9 First edition 2014-05-15 Adhesives Test methods for isotropic electrically conductive adhesives - Part 9: Determination of high-speed signal- transmission characteristics Adhésifs - Méthodes d'essai pour adhésifs a conductivité électrique isotrope Partie 9: Détermination des propriétés de transmission de signal a hautevitesse Reference number ISO 16525-9:2014(E) ISO CopyrightInternatinal Organization for Standardization @ IS0 2014 ed without license from IHS Not for Resale IS0 16525-9:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0 16525-9:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ..1 3 Terms and definitions 4 Principle ..2 5 Apparatus and test circuit board .3 6 Preparation of test circuit board 7 Set-up ..8 8 Tests. .9 8.1 Test procedure. ..9 8.2 Judgement ..10 9 Test report. ..11 Annex A (normative) Sample structure used for the examination .12 Annex B (normative) Test procedure ..25 Annex C (normative) Test equipment and example of implementation of the test ..27 Annex D (normative) Application procedure for isotropic electrically conductive adhesive Example .34 Annex E (normative) Application of isotropic electrically conductive adhesive - Measurement example .36 Bibliography ..45 ii thout license from IHS Not for Resale