ISO INTERNATIONAL STANDARD 16635-2 First edition 2014-09-15 Dentistry Dental rubber dam instruments - Part 2: Clamp forceps Médecine bucco-dentaire - Instruments de digue dentaire en caoutchouc- Partie 2:Pinces porte-crampons Reference number ISO 16635-2:2014(E) LSO IS02014 IHS under lic itted without license from IHS Not for Resale IS0 16635-2:2014(E) COPYRIGHTPROTECTEDDOCUMENT ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 16635-2:2014(E) Contents Page Foreword ..iv Introduction. 1 Scope. 2 Normative references 3 Terms and definitions 4 Requirements .2 4.1 General. .2 4.2 Total length. .2 4.3 Locking part. 2 4.4 Distance between the forceps handles in the closed, passive state .2 4.5 Retaining pins. .2 4.6 Spring and ability to return to the original state .3 4.7 Materials.. 3 4.8 Surfacefinish .3 4.9 Corrosion resistance and resistance to reprocessing .3 5 Test methods. .3 5.1 Visual examination .3 5.2 Dimensions. .3 5.3 Reprocessing. .3 6 Marking 4 iii ded by IHS under lic ense with ISt ed without license from IHS Not for Resale