ISO INTERNATIONAL STANDARD 29803 First edition 2010-01-15 Thermal insulation products for building applications Determination of the resistance to impact of external thermal insulation composite systems (ETics) Produits isolants thermiques destinés aux applications du batiment - Détermination de la resistance au choc des systemes d'isolation thermiquepar I'extérieur (systemes /TE) Reference number ISO 29803:2010(E) @ ISO 2010 Copvriaht International Oraanizatic or Standardization with ISC No reproduction or networking pemitted without license from IHS Not for Resale ISO 29803:2010(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In COPYRIGHT PROTECTED DOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland CoDvriaht In @ IS0 2010 - All rights reserved vith ISC No reproduction or networking permitted without license from IHS Not for Resale ISO 29803:2010(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeen International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. adoptedbythetechnicalcommitteesarecirculatedtothememberbodiesforvoting.Publicationasan International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. built environment, Subcommittee SC 1, Test and measurement methods. ISO 29803 is based on EN 13497:2002 prepared by Technical Committee CEN/TC 88 Thermal insulating materialsandproducts.However, 6.2, conditioning of the test specimens, 7.1, test conditions, and Clause 10, test report tandardization'ghtsreserved ili Not for Resale