BSIS0/ASTM52910:2018 BSl Standards Publication Licensedcopy:IPLogin,UniversityofOxford,Versioncorrectaso Additive manufacturing Design Requirements, guidelines and recommendations bsi. BSIS0/ASTM52910:2018 INTERNATIONAL ISO/ASTM STANDARD 52910 First edition 2018-07-23 Licensed copy: IP Login, University of Oxford, Version correct as of 05/08/2018 Additive manufacturing Design - Requirements, guidelines and recommendations Fabricationadditive-Conception-Exigences, lignesdirectriceset recommandations Reference number IS0/ASTM52910:2018(E) INTERNATIONAL @IS0/ASTMInternational2018 BSIS0/ASTM52910:2018 IS0/ASTM 52910:2018(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0/ASTM International 2018, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying,or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISo at the address below or ISO's member body in the country of the requester. In the United States, such requests should be sent to ASTM International. ISO copyright office ASTM International Ch. de Blandonnet 8 . CP 401 100 Barr Harbor Drive, PO Box C700 CH-1214 Vernier, Geneva, Switzerland West Conshohocken, PA 19428-2959, USA Tel. +41 22 749 01 11 Tel. +610 832 9634 Fax +41 22 749 09 47 Fax +610 832 9635 [email protected] [email protected] www.iso.org www.astm.org ii ISO/ASTM International 2018 - All rights reserved