TECHNICAL ISO/TR REPORT 10314-2 First edition 1991-06-01 Industrial automation - Shop floor production Part 2: Application of the reference model for standardization and methodology Automation industrielle-Production en atelier Partie 2: Application du modele de reference pour la normalisation et la methodologie tso Reference number ISO/TR 10314-2 : 1991 (E) IS0/TR10314-2 : 1991 (E) Contents 0 Introduction iv Scopc 1 1 Methodology for identification of areas of standards 2 2 2.1Anoverviewofthereferencemodel 2 2.2 Procedures 6 Classification ofarcasfor standards 7 2.3 9 3 Guidetousing theprocedures:structuredquestions 3.1 Structuredquestions 9 3.2 Procedure A1: Subject-Action Interrelationships 10 12 3.3Procedure A2: Subject-Subject Interrelationships 14 3.4 Procedure A3: Action-Action Interrelationships 16 3.5 Procedure B1: Horizontal (Contextual)Interrelationships 3.6 Procedure B2: Vertical Interrelationships 17 Identification of areas for standardization 18 4 4.1 ProcedureA1 18 4.2 ProcedureA2 20 4.3ProcedureA3 22 4.4ProcedureB1 24 4.5ProcedureB2 25 Recommendations 25 5 Annexes AMapping of existing standards activities onto the model 26 Ilustrativeareasofstandardsforcellsofthematrices 34 ?ISO1991 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanicai, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case postale 56:CH-1211 Geneve 20.Switzerland Printed in Switzerland ii IS0/TR 10314-2 : 1991 (E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a tcchnical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also takc part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Thc main task of ISO technical committees is to prepare International Standards. In exceptional circumstances a technical committee may propose the publication of a Technical Report of one of the following types: type 1, when the required support cannot be obtained for the publication of an International Standard, despite repeated efforts; type 2, when the subject is still under technical development or where for any other reason there is the future but not immediate possibility of an agreement on an International Standard; type 3, when a technical committee has collected data of a different kind from that which is normally published as an International Standard (state of the art"), for example . Technical Reports of types 1 and 2 are subject to review within three years of publication, to decide whether they can be transformed Into International Standards. Technical Rcports of type 3 do not necessarily have to be reviewed until the data they provide are considered to be no longer valid or useful. ISO/TR 10314-2, which is a Technical Rcport of type 3, was prepared by Technical Committee ISO/TC 184, Industrial automation systems and integration This document is being published in the form of a Technical Report because it is not possible, in view of the current state of the art of modelling for manufacturing, to draw up an International Standard which would be complete and precise, and which would not be too restrictive in this augmentedperiodically, ISO/TR 10314 consists of the following parts under the general title Industrial automation Shop floor production: -Part l: Reference model for standardization and a methodology for identification of requirements Part 2: Application of the reference model for standardization and methodology ii